AMD SB750 Manual de usuario descargar pdf (Pagina 17)

Chapter 2: Using RAID Option ROM

You have successfully created a new RAID logical drive.

Viewing Drive Assignments, Split Physical Drives

After you create two logical drives from the same set of physical drives, press 1

on the Main Menu screen to see the View Drive Assignments screen (below).

In this example, observe how each of the physical drives in Channels 1, 2, and 3

are split between two logical drives. Extent 1 belongs to logical drive 1 (LD 1).

Extent 2 belongs to logical drive 2 (LD 2).

Under Assignment, the physical drives are divided into LD 1 and LD 2. For

example, LD 1-2 means logical drive 1, physical drive 2. LD 2-3 means logical

drive 2, physical drive 3.

Note that the combined size of the extents is slightly smaller than the total

capacity of the physical drive.

Unassigned physical drives are labeled Single Disk. You can use an unassigned

physical drive to create a new logical drive.

Note

You must be partition and format your new logical drive before you

can use it. See “Appendix A: Partition and Format” on page 29.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Sin comentarios

AMD SB750 Manual de usuario Pagina 17